FBC and Unicable config?

    Diese Seite verwendet Cookies. Durch die Nutzung unserer Seite erklären Sie sich damit einverstanden, dass wir Cookies setzen. Weitere Informationen

    • FBC and Unicable config?

      I wonder if anyone can describe how I should set up my new unicable lnb connected to port a on the FBC tuner in my ultimo 4k?

      The current config I have with my universal lnb is attached in picture.lnb.jpg

      My new lnb has the following spec:

      Inverto - IDLB-QUDL42-UNI1L-1PP -

      Low Band Input Frequency Range10.7 ~ 11.7 GHz
      Low Band Output Frequency Range950 ~ 1950 MHz
      Low Band LO Frequency9.75 GHz
      High Band Input Frequency Range11.7 ~ 12.75 GHz
      High Band Output Frequency Range1100 ~ 2150 MHz
      High Band LO Frequency10.6 GHz
      Noise Figure0.7 dB Max.
      LO Initial Accuracy+/- 1.0 MHz Max.
      LO Temperature Drift+/- 2.5 MHz Max.
      Phase Noise (@ 10 kHz)- 90 dBc / Hz Max.
      SCR Conversion Gain57 dB Min.
      Legacy Conversion Gain55 dB Min.
      Gain Ripple (Over 26 MHz Bandwidth)+/- 0.75 dB
      Gain Variation (Over Full Band) +/- 4 dB Max.
      Image Rejection40 dB Min.
      1 dB Compression Point (@ Output)0.0 dBm Min.
      Cross Polarization Isolation22 dB Min.
      Output VSWR2.5 : 1
      In-Band Spurious- 60 dBm Max.
      Output IF Channel 1 (SCR0) 1210 MHz
      Output IF Channel 2 (SCR1)1420 MHz
      Output IF Channel 3 (SCR2)1680 MHz
      Output IF Channel 4 (SCR3) 2040 MHz
      Channel Isolation20 dB Min.
      Legacy Ports1
      SCR's Control Signals DiSEqC command extension based on EN-50494
      Legacy Switch Voltage Control < 14.2 V (Vertical), > 15 V (Horizontal)
      Legacy 22 k Sensitivity 220 mV Min.
      Current Consumption250 mA Max. @ 13.5 V
      Operating Temperature- 30 °C ~ + 60 °C
      Output Impedance75 Ω
      Output ConnectorF-Type (Female)
      Weight350 g

    • You need so set it to advanced (I hope it is called advanced in English, at least something else as "simple")

      Then select Unicable, your brand (Inverto), your device (IDLB...), and then you need to set SRC0 to Tuner A, SCR1 to B, and so on.
      B has to be connected with A, C with B, ... and so on.

      Here more info, but it is in German: Tunerkonfiguration Vu+ Solo 4K mit einem DVB-S2 FBC Dual Tuner und einem DVB-S2 Dual Tuner – Vu+ WIKI

      It is for the Solo 4k but the principle is the same so that doesn't matters
      Docendo Discimus
      KEIN SUPPORT PER PN!

      Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von Clemens ()