Multistream not working

    Diese Seite verwendet Cookies. Durch die Nutzung unserer Seite erklären Sie sich damit einverstanden, dass wir Cookies setzen. Weitere Informationen

    • Ja danke! It is true. ALL MIS mux now working OK. Thanks VTI Team !!!

      Only one problem on Hispasat 30 west, TP 11496 H, SR 7884 FEC 8/9, DVB-S2/8PSK, PLS mode: ROOT, PLD code: 185747, ID: 0. The signal is srong, but strange, still signal up/down. Please can somebody confirm this problem?? Thanks!!
      Dateien
    • @usingen
      thanks for you shot
      may be an issue on drivers (i hope in soft not hard ) because you used different modes and will be fixed soon
      can you test the same tp but with combo ????
      please
      11496 H
      DVB-S2/8PSK
      MPEG-2
      MPEG-4
      PLS
      COMBO 25613
      7884 8/9

      @ MAJOOR
      can you test this tp on 5°W
      11448 H 1703
      DVB-S2 8PSK
      5/6

      or
      signal ok ?
      if yes
      box can scan it ?
    • @ MAJOOR
      thanks for test but there is a signal on this TP may be you dish is small or isn't fixed very well on 5°W.
      @usigen
      thanks fortest too
      drivers are so new and is the 1st time that VU+ CMT plays with mis/pls and i think that VTI team can't fix this issue without a new driver from VU+ CMT (are u testd other image and the problem still the same ) ?
      2- i now that's not a MIS tp but i want to know if ZERO 4K can scan it like tbs 6983

      Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von hgdo () aus folgendem Grund: unnötiges Komplettzitat entfernt

    • Crazycat removed Combo-mode....why?heres the answer ,found in "Rick Sat Forum: """Jut removed fake PLS Mode This some STm-specific mode for Gold->Root code conversion You write mode 2 and Gold code to registers and demod calculate Root code and change mode field to 0 (Root mode). First time this was bad-documented for STV090x and next time fixed in STV091x docs.""""
    • T2-MI not working with VTI image unfortunately. With image Open ATV it is working, but the metod is relativ difficult.

      Some pictures from MIS TP from all orbital position:
      Dateien

      Dieser Beitrag wurde bereits 3 mal editiert, zuletzt von usingen ()

    • usingen schrieb:

      Ja danke! It is true. ALL MIS mux now working OK. Thanks VTI Team !!!

      Only one problem on Hispasat 30 west, TP 11496 H, SR 7884 FEC 8/9, DVB-S2/8PSK, PLS mode: ROOT, PLD code: 185747, ID: 0. The signal is srong, but strange, still signal up/down. Please can somebody confirm this problem?? Thanks!!

      Soweit mir bekannt hat die VU+ Zero 4K denselben Demodulator von Silabs wie die Octagon SF 4008. Dieser Demodulator hat Probleme bei der Darstellung dieses Transponders. Das Problem ist bei Octagon auch ungelöst, weil es wohl hardwaretechnisch nicht richtig funktioniert ?!? Deshalb würde ich mir hier keine großen Hoffnungen machen..


      Meine TBS 5925, per USB an der VU Solo SE V2 hängend, kann diesen Transponder problemlos darstellen. Meine Octagon SF 4008 kann dieses nicht.


      Vu+ Zero 4K DVB-S2X mit Turbo Tuner Box DVB-T2 HD
      Vu+ Uno 4K SE DVB-S2X mit Turbo Tuner Box DVB-T2 HD
      Vu+ Duo 4K SE DVB-S2X und DVB-T2 Dualtuner

      Jultec Einkabelumsetzer JPS1704-4T für 4 Satelliten
      Kathrein Cas 90 1,9° O /5°W
      Kathrein Cas 90 9°O /13°O /19,2°O
      Kathrein Cas 90 42°O
      Fuba DAA 110 Rotor von 45°W bis 57°O

      Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von Postmann_x ()

    • @Postmann_x
      not right your information
      sf 4008 tuiner built on chipset SI21662-D / dvbs-Blindscan may be can't i think isn't drivers and patch problem trhat's needs

      ZERO 4 K NIM2166-D/ dvbs-Blindscan ok

      SF 4008 can't combo mode
      ZERO 4K can @usingen confirms
      so are differents tuner
      i said yesterday that this issue only VU+ CMT can fix it by new drivers.


      SF 4008 chipset
      Si21672/662-D Dual Digital TV Demodulators

      Each of the Si21672/662-D dual demodulators integrate two separate high-performance single demodulators in a compact 8 x 8 mm QFN package. The Si21672/662-D support DVB-S2X/S2/T/C/S and DVB-S2X/S2/S, respectively. Leveraging Silicon Labs' proven digital demodulation architecture, each embedded demodulator achieves excellent reception performance for each media while significantly minimizing front-end design complexity and cost. Connecting the Si21672/662-D to both a dual terrestrial/cable TV tuner, and a dual satellite tuner, results in a high-performance and cost optimized dual-channel TV or STB front-end solution.

      Features
      Spoiler anzeigen

      • DVB-S2 (ETSI EN 302 307-1)
        • QPSK/8PSK demodulator
      • DVB-S2X (ETSI EN 302 307-2)
        • QPSK/8PSK, 8/16/32APSK demodulator
        • Roll-off factors from 0.05 to 0.35
      • DVB-C (ETSI EN 300 429) and ITU-T J.83 Annex A/B/C
        • QAM demodulator and FEC decoder
        • 1 to 7.2 M Symbol(s)
      • DVB-T (ETSI EN 300 744)
        • OFDM demodulator and enhanced FEC decoder
        • NorDig Unified 2.4, D-Book 7 V3 compliant

      • DVB-S (ETSI EN 300 421) and DSS
      • 1 to 45 MSymbol/s for all satellite standards (<40 MSps in 32APSK)
      • LDPC and BCH decoding for S2X/S2 standards
      • Dual DiSEqC™ 2.x interface, Unicable support
      • Enhanced immunity to co-channel interferers
      • I2C serial bus interfaces (master and host)
      • Dual independent differential IF input for T/C tuners and differential ZIF I/Q inputs for satellite tuners
      • GPIOs and multi-purpose ports (two per demodulator)

      • Firmware control for upgradeability
      • Separate flexible TS interfaces with serial or parallel outputs, and cross-bar feature
      • Fast lock times for all media
      • Only two power supplies: 1.2 and 3.3 V
      • 8 mm x 8 mm, QFN68 package, Pb-free/RoHS compliant
      • Pin-to-pin compatible with Si216x2/8x2 dual demods family
      • API compatible with all single and dual demods families


      ZERO 4K

      Si2166-D Satellite TV Demodulator (DVB-S2X/S2/S)

      The Si2166-D satellite demodulator IC combines digital-video broadcast (DVB) satellite functions in one highly integrated device. The Si2166-C provides a single-chip, multi-standard solution that helps simplify the design of complex video front-ends now common in iDTV and STB designs.
      The Si2166-D integrates digital demodulators for first and second generation satellite DVB standards, DVB-S2 and DVB-S2X/S2, respectively, in a single advanced CMOS die. Leveraging Silicon Labs' proven digital demodulation architecture, the Si2166-D achieves excellent satellite reception performance while significantly minimizing front-end design complexity, cost and power dissipation. Connecting the Si2166-D to a satellite silicon tuner results in a high-performance and cost optimized TV or STB front-end solution.
      The satellite demodulation functionality allows demodulating widespread DVB-S, DIRECTV™ (DSS), DVB-S2, and DIRECTV™ (AMC) legacy standards, as well as new Part II of DVB-S2 (S2X) satellite broadcast standard. Broadcast services, variable coding and modulation (VCM), 8, 16, 32 APSK modulations and code rates, new shorten roll-off factors, are the main specifications of the new DVB-S2 demodulator. A zero-IF interface allows for a seamless connection to market proven satellite silicon tuners. It also integrates DiSEqC™ 2.0 LNB interface for satellite dish control and an equalizer to compensate for echoes in long cable feeds from the LNB to the satellite tuner RF input.
      The Si2166-C IC enables a low-cost system implementation due to its minimal BOM and very small package footprint (7 mm x 7 mm, 48-pin QFN). Benefiting from its compact form factor and reduced power dissipation in DVB-S2X/S2, it is ideal for module (NIM) integration or on-board design.

      Features

      Spoiler anzeigen


      • DVB-S2 (ETSI EN 302 307-1)
        • QPSK/8PSK demodulator
      • DVB-S2X (ETSI EN 302 307-2)
        • QPSK/8PSK, 8/16/32APSK demodulator
        • Roll-off factors from 0.05 to 0.35
      • DVB-S (ETSI EN 300 421) and DSS
        • QPSK demodulator and enhanced FEC decoder

      • 1 to 45 MSymbol/s for all satellite standards (<40 MSps in 32APSK)
      • DIRECTV™ DSS compliant/AMC compatible
      • DiSEqC™ 2.0 interface and Unicable support
      • Two ADCs with differential input (ZIF input)
      • I2C serial bus interfaces (master and host)
      • Fast lock times
      • Only two power supplies: 1.2 V and 3.3 V

      Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von hgdo ()

    • @sami noor

      Yes, I tested 4:2:2 on Zero 4K, black screen, stream to PC via VLC nice picture.
      Yes I confirm, PLS mode Combo working very well. Tested on Hispasat 30W, TP 11496 H, combo pls code 25613.
      Other combo code on MIS TP is unknown (or not calculated). All MIS TP send in ALL PLS mode, practicaly combo mode is not necessary, when is known root or gold code.