I have vu+solo2 orginal box and i also check with given pdf files in forum issuse is that when i buy my box the official software was installled in the box so i update the box with official u download site Vu+ Update works all good the blackhole image 3.0.2 about three year i used that onday when i start my box show HW error on lead soi do many image to get rid from this error but no success yet experts help me
Note my box is stuck on 2.0.7 black hole image no official image works no clone image works only one image 2.0.7 works any solution if some one understand this issue
some one wrote me this (You are right, your box is original.
So to fix the "HW Error" that means that the FPGA Security chip wasn't upgraded to the latest software, you would have most probably to flash an image from beggining of 2014 (and/or Bootloader) that will upgrade your FPGA chip.) kndly giv e correct firmwqare for resolvin g the issue
few pic i attached of the board ok
Note my box is stuck on 2.0.7 black hole image no official image works no clone image works only one image 2.0.7 works any solution if some one understand this issue
some one wrote me this (You are right, your box is original.
So to fix the "HW Error" that means that the FPGA Security chip wasn't upgraded to the latest software, you would have most probably to flash an image from beggining of 2014 (and/or Bootloader) that will upgrade your FPGA chip.) kndly giv e correct firmwqare for resolvin g the issue
few pic i attached of the board ok